Serial Binding

Documentation of the Serial binding Bundle

Introduction

For installation of the binding, please see Wiki page Bindings.

Generic Item Binding Configuration

In order to bind an item to a Serial device, you need to provide configuration settings. The easiest way to do so is to add some binding information in your item file (in the folder configurations/items`).

The format of the binding configuration is simple and looks like this: serial="" where {{{}}} is the identification of the serial port on the host system, e.g. "COM1" on Windows, "/dev/ttyS0" on Linux or "/dev/tty.PL2303-0000103D" on Mac.

Switch items with this binding will receive an ON-OFF update on the bus, when ever data becomes available on the serial interface (or simply by short-cutting pins 2 and 7 on the RS-232 interface)

String items will receive the submitted data in form of a string value as a status update, while openHAB commands to a String item is sent out as data through the serial interface.

As a result, your lines in the items file might look like the following: Switch HardwareButton "Bell" (Entrance) { serial="/dev/ttyS0" } String AVR "Surround System" (Multimedia) { serial="/dev/ttyS1" }

Note: If you are working with a Mac, you might need to install a driver for your USB-RS232 converter (e.g. http://osx-pl2303.sourceforge.net/ or http://mac.softpedia.com/get/Drivers/Prolific-PL-2303.shtml) and create the /var/lock folder, see the rxtx troubleshooting guide.